GME50.01
First edition
Published on: 01/04/1992
Cork mouth finish for corks and capsules
Scope of application
This data sheet specifies the dimensions of a cork mouth finish for corks and capsules for glass bottles, for wine that has a carbonation pressure not exceeding 2.0 g CO2/l, for use with natural corks.
Table of contents
Recommendation
Dimensions
Notes
Dimensions
Notes
History
First edition: 04/1992
Data sheet replaced by standard EN 12726 - PACKAGING - CORK MOUTH FINISH WITH A BORE DIAMETER OF 18,5 MM FOR CORKS AND TAMPER EVIDENT CAPSULES
First edition: 04/1992
Data sheet replaced by standard EN 12726 - PACKAGING - CORK MOUTH FINISH WITH A BORE DIAMETER OF 18,5 MM FOR CORKS AND TAMPER EVIDENT CAPSULES
Contributors
AGI GLASPAC, ANFEVI (ASOCIACION NACIONAL DE FABRICANTES DE ENVASES DE VIDRIO), ARDAGH GLASS GMBH, ARDAGH GLASS PACKAGING S.A PROPERTY LIMITED, ARDAGH GROUP NETHERLAND B.V., ARDAGH GROUP S.A. POLAND, BA GLASS PORTUGAL, BRITISH GLASS, BUNDESVERBAND GLASINDUSTRIE E.V., CSVMF (CHAMBRE SYNDICALE DES VERRERIES MÉCANIQUES), GERRESHEIMER ESSEN GMBH, GERRESHEIMER MOMIGNIES, GERRESHEIMER TETTAU GMBH, O-I MANUFACTURING DEUTSCHLAND, O-I MANUFACTURING FRANCE, O-I MANUFACTURING ITALY, O-I MANUFACTURING UK, O-I MANUFACTURING US, SAUDI ARABIAN GLASS CO. LTD, SAVERGLASS, VERALLIA FRANCE, VERALLIA GERMANY, VETROPACK HOLDING AG, VETROPACK STRADA, VIDRALA, WIEGAND-GLASHUTTENWERKE
Document under responsibility of working group:
Glass wg3
WG chair: Niall MC GRATH - ENCIRC GLASS
This permanent group is dedicated to the creation and revision of Cetie's "GME*" neck finishes data sheets, and also to the revision of equivalent neck finishes data sheets previously submitted to official standardisation (ISO and/or CEN), dedicated to the production of glass bottles and jars for the food and beverage sectors. These neck finishes data sheets concern the following applications: ROPP, aluminum screw caps, crown caps, twist-off caps, cork or synthetic stoppers, bar-top, or swing stoppers.
*Initiated by the glass industry in the 1960s, the acronym 'GME' stands for 'Glass Manufacturing Experimental'. The idea was that Cetie, as an unofficial standards body, would only publish 'experimental' data sheets, before submitting these to the official standards bodies. At the same time, in the USA, the acronym 'GME' was also used. As the original meaning was lost over time, this nomenclature for Cetie's glass finishes documents has been, later on, applied to the PET finish data sheets.
*Initiated by the glass industry in the 1960s, the acronym 'GME' stands for 'Glass Manufacturing Experimental'. The idea was that Cetie, as an unofficial standards body, would only publish 'experimental' data sheets, before submitting these to the official standards bodies. At the same time, in the USA, the acronym 'GME' was also used. As the original meaning was lost over time, this nomenclature for Cetie's glass finishes documents has been, later on, applied to the PET finish data sheets.
Document suppressed from library
